/r/AskElectronics

Year:

Only show posts with narrations

I have no idea what these integrated circuits are. I'm curious about the last one (left to right). Could not find it on the internet. Maybe gate drivers?

3 upvotes • gvbO_

Mark as read: Add to a list

Question on diodes

3 upvotes • Ayman_Rocco980

Mark as read: Add to a list

Transformer lamination sourcing?

3 upvotes • girafb0y

Mark as read: Add to a list

Blown MOV, looking to spec for replacement

3 upvotes • Acceptable_Let_5855

Mark as read: Add to a list

Help with monitor controller/ mixer - TL072 getting Hot

3 upvotes • Fraenkthedank

Mark as read: Add to a list

Fix broken and corroded battery holder

3 upvotes • __bazzinga__

Mark as read: Add to a list

Can someone identify this fried resistor?

3 upvotes • Name-Saibuu

Mark as read: Add to a list

Can I run both rails off this power supply in parallel? And yes I know I slapped the cap, I'll solder it first.

3 upvotes • WhyIsSocialMedia

Mark as read: Add to a list

I'm making a board with an esp-32, LTE wireless transmitter/reciever, a GPS reciever, and a temperature/humidity sensor. This is a bit outside of what i feel confident in designing so I was just wondering if there were any obvious design mistakes that i have missed.

3 upvotes • Murdering_Baguette

Mark as read: Add to a list

What techniques can a hobbyist use to draw a schematic from a commercial PCB?

3 upvotes • homehandyman

Mark as read: Add to a list

Title	Upvotes	Author	Mark as read	Favorited	Rating	Add to a list
I have no idea what these integrated circuits are. I'm curious about the last one (left to right). Could not find it on the internet. Maybe gate drivers?	3	gvbO_
Question on diodes	3	Ayman_Rocco980
Transformer lamination sourcing?	3	girafb0y
Blown MOV, looking to spec for replacement	3	Acceptable_Let_5855
Help with monitor controller/ mixer - TL072 getting Hot	3	Fraenkthedank
Fix broken and corroded battery holder	3	__bazzinga__
Can someone identify this fried resistor?	3	Name-Saibuu
Can I run both rails off this power supply in parallel? And yes I know I slapped the cap, I'll solder it first.	3	WhyIsSocialMedia
I'm making a board with an esp-32, LTE wireless transmitter/reciever, a GPS reciever, and a temperature/humidity sensor. This is a bit outside of what i feel confident in designing so I was just wondering if there were any obvious design mistakes that i have missed.	3	Murdering_Baguette
What techniques can a hobbyist use to draw a schematic from a commercial PCB?	3	homehandyman