/r/Metrology

Year:

Only show posts with narrations

Apparently my first post looked like I'm a bot.....Hexagon head for sale. Not a bot.

3 upvotes • KCMOMachineShop2

Mark as read: Add to a list

Is this 3-D scanner relevant?

3 upvotes • memiusprime

Mark as read: Add to a list

Looking for Zeiss pro to do onsite in North Texas. OEM does not service Eclipse circa97 was working but RDSCAA bugged out doesn't read sensors . it rotates but no signal. Zeiss wontSend a service tech. I replaced XXT adaptersensor but before i just buy rds i would like a skilled person

2 upvotes • Ashamed_Two_4722

Mark as read: Add to a list

Rapid inspection of large, tight-tolerance components — CMM QUARTERLY

2 upvotes • Practical_Rest4101

Mark as read: Add to a list

(Re-posted from r/Arduino) Is using a rod of known length (5cm) to press on a scale a good way to measure torque? When I tested it, the scale said 7.5 kg for 5cm, but the mg996r should be 10kg/cm. How do I measure torque reliably?

2 upvotes • BuySplendidPie

Mark as read: Add to a list

Scan on that thang

1 upvotes • easydoesitbud

Mark as read: Add to a list

How to make your drawing checkers life easier, and get your drawings released

1 upvotes • iSwearImAnEngineer

Mark as read: Add to a list

Keyence VR-6000

1 upvotes • BlightBuddha

Mark as read: Add to a list

Beckman J26XP

1 upvotes • Jlecocq

Mark as read: Add to a list

LK Metrology CMM With Star Probe Struggling with Alignment

1 upvotes • Open_Maize_4538

Mark as read: Add to a list

Title	Upvotes	Author	Mark as read	Favorited	Rating	Add to a list
Apparently my first post looked like I'm a bot.....Hexagon head for sale. Not a bot.	3	KCMOMachineShop2
Is this 3-D scanner relevant?	3	memiusprime
Looking for Zeiss pro to do onsite in North Texas. OEM does not service Eclipse circa97 was working but RDSCAA bugged out doesn't read sensors . it rotates but no signal. Zeiss wontSend a service tech. I replaced XXT adaptersensor but before i just buy rds i would like a skilled person	2	Ashamed_Two_4722
Rapid inspection of large, tight-tolerance components — CMM QUARTERLY	2	Practical_Rest4101
(Re-posted from r/Arduino) Is using a rod of known length (5cm) to press on a scale a good way to measure torque? When I tested it, the scale said 7.5 kg for 5cm, but the mg996r should be 10kg/cm. How do I measure torque reliably?	2	BuySplendidPie
Scan on that thang	1	easydoesitbud
How to make your drawing checkers life easier, and get your drawings released	1	iSwearImAnEngineer
Keyence VR-6000	1	BlightBuddha
Beckman J26XP	1	Jlecocq
LK Metrology CMM With Star Probe Struggling with Alignment	1	Open_Maize_4538