/r/OrcaSlicer

Year:

Orca vs Bambu Lab calibration hierarchy?

1 upvotes • rimbooreddit

Mark as read: Add to a list

How to block supports in hard to get areas

1 upvotes • Negative_Ant4437

Mark as read: Add to a list

Pause at layer not working

1 upvotes • Royal-Shame-2159

Mark as read: Add to a list

I'm trying to fine-tune a process for light boxes and I'd like to manually add ironing after only layer 1. Is there a way to do that, even manually in the gcode?

1 upvotes • Ostojo

Mark as read: Add to a list

Is there any way to generate support interfaces on tree supports like PrusaSlicer?

1 upvotes • CrazyHairGuy11

Mark as read: Add to a list

Stringing and extruder skipping help

1 upvotes • AbsoluteRED_

Mark as read: Add to a list

Given that I have the E3D Revo Hemera hot end with direct drive, I have the ability to quickly swap out nozzles with my fingers with the quick exchange system. I recall reading that switching between nozzle size profiles on ORCA is not as intuitive as other slicers. Has this changed at all? Thanks!

1 upvotes • KillerQ97

Mark as read: Add to a list

Title	Upvotes	Author	Mark as read	Favorited	Rating	Add to a list
Orca vs Bambu Lab calibration hierarchy?	1	rimbooreddit
How to block supports in hard to get areas	1	Negative_Ant4437
Pause at layer not working	1	Royal-Shame-2159
I'm trying to fine-tune a process for light boxes and I'd like to manually add ironing after only layer 1. Is there a way to do that, even manually in the gcode?	1	Ostojo
Is there any way to generate support interfaces on tree supports like PrusaSlicer?	1	CrazyHairGuy11
Stringing and extruder skipping help	1	AbsoluteRED_
Given that I have the E3D Revo Hemera hot end with direct drive, I have the ability to quickly swap out nozzles with my fingers with the quick exchange system. I recall reading that switching between nozzle size profiles on ORCA is not as intuitive as other slicers. Has this changed at all? Thanks!	1	KillerQ97