StoryNote logo

/r/ender3

yet another problem… why isn’t my Z-Axis moving? this is only when i print, it works fine otherwise

1 upvotes • Financial_Option_757
Mark as read:
Add to a list

Adding a newer laser module to an Ender 3 Pro

1 upvotes • LFoxter
Mark as read:
Add to a list

Warranty?

1 upvotes • Darkstarx97
Mark as read:
Add to a list

Sprite pro heating issues

1 upvotes • TheJuippi
Mark as read:
Add to a list

Running Marlin w/ jyersUI. Which fan is supposed to get adjusted with this setting? For me it adjusts the fan over the control board…

1 upvotes • slimshadysshadow
Mark as read:
Add to a list

Axial vs radial fan

1 upvotes • ArmPsychological8460
Mark as read:
Add to a list

Cr10 se vs ender 3 ke

1 upvotes • Aveyator2008
Mark as read:
Add to a list

Someone help out with Pause/Resume gcode. Need to extend idle timeout when the filament sensor pauses print. Currently I have to home everything when it happens because I'm at work when the filament runs out.

1 upvotes • Randomhero360
Mark as read:
Add to a list

Layer shift, then shifted back?

1 upvotes • Three_hrs_later
Mark as read:
Add to a list

I hate to say it but I don't know everything...

1 upvotes • HonestPassenger2314
Mark as read:
Add to a list
« < > »
Page of 27

StoryNote©

About Contact Terms Privacy Cookie

Reddit is a registered trademark of Reddit, Inc. Use of this trademark on our website does not imply any affiliation with or endorsement by Reddit, Inc.