/r/klippers

Year:

Only show posts with narrations

SKR 3 V3 MCU 'mcu' configured for 400Mhz but running at 500Mhz!

3 upvotes • Reasonable_Dirt1199

Mark as read: Add to a list

Ski-slope bed V3-SE

3 upvotes • Automatic_Soja

Mark as read: Add to a list

100mm's on the left, 80mm's on the right. What is causing 100mm's to get rough with the corners below and above the X on this calibration cube?

3 upvotes • Duckers_McQuack

Mark as read: Add to a list

Firmware restore

2 upvotes • pelsohu

Mark as read: Add to a list

Pi-mainboard connection

2 upvotes • Itsspelleddylan

Mark as read: Add to a list

Mainsail Klipper Problem

2 upvotes • PositiveMaterial3899

Mark as read: Add to a list

Macro to always use E0 for G28 since E1 doesn't have a probe. (IDEX)

2 upvotes • PukinDog4President

Mark as read: Add to a list

Klipper or Mainsail or SKR E3 Mini? Which is driving me crazy?

2 upvotes • Terrible_Clerk_1565

Mark as read: Add to a list

MCU Failed to update, While printing?

2 upvotes • Gr8GatzB

Mark as read: Add to a list

Sonic Pad ABL no longer working.

2 upvotes • the_breadsticks

Mark as read: Add to a list

Title	Upvotes	Author	Mark as read	Favorited	Rating	Add to a list
SKR 3 V3 MCU 'mcu' configured for 400Mhz but running at 500Mhz!	3	Reasonable_Dirt1199
Ski-slope bed V3-SE	3	Automatic_Soja
100mm's on the left, 80mm's on the right. What is causing 100mm's to get rough with the corners below and above the X on this calibration cube?	3	Duckers_McQuack
Firmware restore	2	pelsohu
Pi-mainboard connection	2	Itsspelleddylan
Mainsail Klipper Problem	2	PositiveMaterial3899
Macro to always use E0 for G28 since E1 doesn't have a probe. (IDEX)	2	PukinDog4President
Klipper or Mainsail or SKR E3 Mini? Which is driving me crazy?	2	Terrible_Clerk_1565
MCU Failed to update, While printing?	2	Gr8GatzB
Sonic Pad ABL no longer working.	2	the_breadsticks