StoryNote logo

/r/PrintedCircuitBoard

My first home made PCB of the Year.

30 upvotes • motherbright
Mark as read:
Add to a list

Is it bad to use an MC board in a finished design instead of laying its components out on the PCB?

26 upvotes • blajjefnnf
Mark as read:
Add to a list

Why learn pcb design?

24 upvotes • Glittering-Target-87
Mark as read:
Add to a list

Is this ok or will it cause problems? STM32F4 MCU with 32kHz (upper) and 8MHz (lower). Ground pour on both layers

23 upvotes • Impossible-Visit-775
Mark as read:
Add to a list

[PCB Review Request] Tiny buck regulation module

20 upvotes • 4b686f61
Mark as read:
Add to a list

[PCB Review Request] 7.5A, 24V Boost Converter

19 upvotes • JustTheLeftoverPizza
Mark as read:
Add to a list

[Review request] Pumps controller - first time USB, SPI, XTAL and inductive load, third revision

19 upvotes • LadyOfCogs
Mark as read:
Add to a list

[Review request] Guitar ADC/DAC board

16 upvotes • NodeModd
Mark as read:
Add to a list

[Review request] Pumps controller - first time USB, SPI, XTAL and inductive load, second revision

16 upvotes • LadyOfCogs
Mark as read:
Add to a list

[PCB Review] CH32V208 BLE environmental sensor

14 upvotes • passcod
Mark as read:
Add to a list
« < > »
Page of 10

StoryNote©

About Contact Terms Privacy Cookie

Reddit is a registered trademark of Reddit, Inc. Use of this trademark on our website does not imply any affiliation with or endorsement by Reddit, Inc.