StoryNote logo

/r/PrintedCircuitBoard

Is low melt(138°C) solderpaste ok to use for assembly?

7 upvotes • MetallSimon
Mark as read:
Add to a list

Long time Eagle user, noted the2026 discontinuation, is there anything I switch to that is practically seamless / better?

7 upvotes • InsertTitles
Mark as read:
Add to a list

[schematic review request] why might this be getting hot when INSERT_DETECT is high?

7 upvotes • brotoro
Mark as read:
Add to a list

[PCB Review Request] STM32F072 Numpad with USB-C

6 upvotes • suck-a-cactus
Mark as read:
Add to a list

[PCB Review Request] ATmega238P-based water tank monitor

6 upvotes • inoskyh
Mark as read:
Add to a list

[Schematic Review Request] USB-C Lipo Charger with 5v boost

6 upvotes • Retro_Gamer
Mark as read:
Add to a list

[Schematic and PCB Review] A Tracking Module

5 upvotes • Opposite-Fox8602
Mark as read:
Add to a list

[PCB Review Request] STM32F103 Breakout board with two UARTs

5 upvotes • RarePossum
Mark as read:
Add to a list

LM2596 Buck converter

5 upvotes • Dessert_Eagle_09
Mark as read:
Add to a list

Ground and power lines on a double sided pcb layout

5 upvotes • SweatyBoard9054
Mark as read:
Add to a list
« < > »
Page of 10

StoryNote©

About Contact Terms Privacy Cookie

Reddit is a registered trademark of Reddit, Inc. Use of this trademark on our website does not imply any affiliation with or endorsement by Reddit, Inc.