/r/octoprint

Year:

Only show posts with narrations

OctoApp Webcam

8 upvotes • callisto92

Mark as read: Add to a list

Stringing with Octolapse, but only when using a stabilization profile other than "Snap to Print" - Any advice to get rid of this? Tried increasing retraction and enabling retract on layer change. Using OrcaSlicer.

6 upvotes • TheVillainInThisGame

Mark as read: Add to a list

Almost all

5 upvotes • Correct_Middle7856

Mark as read: Add to a list

Octo4a disconnects at specific reason

2 upvotes • WendyKuro

Mark as read: Add to a list

Octoprint not playing well with Creality CR-M4

1 upvotes • _Fisz_

Mark as read: Add to a list

updated Octopi after 7 years and now losing connection

1 upvotes • Bl1ndMous3

Mark as read: Add to a list

Almost all

1 upvotes • Correct_Middle7856

Mark as read: Add to a list

Title	Upvotes	Author	Mark as read	Favorited	Rating	Add to a list
OctoApp Webcam	8	callisto92
Stringing with Octolapse, but only when using a stabilization profile other than "Snap to Print" - Any advice to get rid of this? Tried increasing retraction and enabling retract on layer change. Using OrcaSlicer.	6	TheVillainInThisGame
Almost all	5	Correct_Middle7856
Octo4a disconnects at specific reason	2	WendyKuro
Octoprint not playing well with Creality CR-M4	1	_Fisz_
updated Octopi after 7 years and now losing connection	1	Bl1ndMous3
Almost all	1	Correct_Middle7856