/u/sawthegap42's posts

Year:

Only show posts with narrations

I know I know, rails down, but I did not like how the internal structure turned out after removing supports with rails down, so tried again rails up, and really please with the results. Link to whos settings I used will be posted below.

85 upvotes • r/fosscad

Mark as read: Add to a list

Had both extruder motor bolt holes strip out today without warning. Never even felt tightening resistance. Was putting the screws in after clearing a clog, then noticed both sides pushing threads out. Luckily I had some longer screws with nuts I could use.

1 upvotes • r/crealityk1

Mark as read: Add to a list

Title	Upvotes	Subreddit	Mark as read	Favorited	Rating	Add to a list
I know I know, rails down, but I did not like how the internal structure turned out after removing supports with rails down, so tried again rails up, and really please with the results. Link to whos settings I used will be posted below.	85	fosscad
Had both extruder motor bolt holes strip out today without warning. Never even felt tightening resistance. Was putting the screws in after clearing a clog, then noticed both sides pushing threads out. Luckily I had some longer screws with nuts I could use.	1	crealityk1